EWP150 Alloy & Digital Controller Combo (12V)
The EWP150 Alloy (24V) Electric Water Pump - univresal fit, do-it-yourself, easy to install water pump designed to replace or compliment your existing belt-driven mechanical water pump. By removing the parasitic power losses of a belt-driven water pump the EWP can provide up to 10kW of extra power, increased torque, increased cooling capacity, eliminating heat soak and provide better engine temperature control.
Technical Specifications |
Kit Contents |
Operating voltage |
3V DC to 15V DC |
EWP150 Alloy Pump |
1 |
Maximum current |
10A |
EWP & FAN Digital Controller |
1 |
Flow rate |
150 L/min (40 US gal/min) |
Inline Adaptor |
1 |
Operating temp |
-40 to 130C (-40 to 266F) |
Wiring Harness with 10A Fuse |
1 |
Pump design |
Clockwise Centrifugal |
Rubber Sleeves 3mm |
4 |
Pump Material |
Aluminium |
Hose Clamps |
4 |
Pump weight |
1,170 grams (2.60lbs) |
Hardware Bag: Relay, Scotch Lock, Ring Terminal, Self Tapper |
1 |
Burst pressure |
500 kPa (72.5 psi) |
|
|
Dimensions |
128mm x 85mm x 188mm |
|
|
Hose Sizes |
38mm to 51mm (1-1/2" to 2") |
|
|
Inlet & Outlet |
Internal Thread AN-16 |
|
|
This high capacity EWP®150 (40 US Gal/Min) is designed to replace and/or complement the existing belt driven mechanical water pump and when fitted with the Digital Controller, replaces the thermostat.
The major benefits a EWP®150 offers are:
Minimise the parasitic power losses running a mechanical water pump at high speed when not needed Maximise engine warm-up & minimise the effects of heat soak by operating the EWP®150 after engine shut down.
From start-up, the EWP® & Fan Digital Controller will 'system check' the EWP®150 and Thermatic Fan operating the pump and fan for approx. 10 seconds. Low engine temperature, low flow (10-on - 30-off pwm) reduces engine warm-up time, arriving at your targeted/set temperature quicker, assisting control the engine temperature within your -5 to +3 degree targeted/set temperature range. The Electric Thermatic Fan/s will be deployed at +3◦C above targeted/set temp if slower travel (traffic) or engine idle conditions continue. The EWP® & Fan Digital Controller will continue operating after a hot engine shut down for a approx. 2 minute period to help prevent damaging heat soak.